AMS ENS210 Element
The ENS210 element is used to measure ambient temperature and humidity. This element is for using the AMS ENS210 humidity and temperature sensor.
The ENS210 is a sensor element that can be imported into the Element Toolbox through the Add Elementbutton located in the toolbox from the Embedded tab. NXP Rapid IoT projects have this element imported by default.
The following properties can be changed for the ENS210 element:
The name of the element.
I2C Driver Instance
The I2C bus used to communicate with the sensor.
The I2C address the element sends data to.
Temperature Calibration Offset
The calibration setting to offset the temperature value.
The following triggers are available to execute events from within the ENS210 element:
Execute an event when the source element connected to the ENS210 triggers.
Execute an event when temperature data is read.
Execute an event when humidity data is read.
The following abilities are available for the ENS210 element when its source element triggers:
Trigger the element(s) that follow the ENS210 element.
Enable the sensor.
Disable the sensor.
Set Enabled State
Set the state of the sensor: enabled or disabled.
Read Temperature (C)
Read the sensor’s temperature data in Celsius.
Read Humidity (%rh)
Read the sensor’s humidity data in relative humidity percentage.