MikroElektronika Motion Click Element

The motion click element is used to detect motion from a live body. This element is for using the MikroElektronika Motion Click board.

This element is asynchronous, and will execute the Motion Detected trigger whenever motion is detected with a 1 second cooldown.

The motion click is a sensor element that can be imported into the Element Toolbox through the Add Element Add Element button located in the toolbox from the Embedded tab.


The following properties can be changed for the motion click element:


The name of the element.

GPIO Driver Instance

The GPIO driver instance number to use.

Enable Pin

The GPIO pin used to enable retriggerable and non-retriggerable mode selection.

Motion Pin

The GPIO pin used for motion output detection.


The following triggers are available to execute events from within the motion click element:


Execute an event when the source element connected to the motion click triggers.

Motion Detected

Execute an event when a motion event is detected.


The following abilities are available for the motion click element when its source element triggers:


Trigger the element(s) that follow the motion click element.