MikroElektronika Pressure 4 Click Element

The pressure 4 click element is used to measure barometric pressure and temperature. This element is for using the MikroElektronika Pressure 4 Click board, which features the Bosch BMP280 barometric pressure sensor.

The pressure 4 click is a sensor element that can be imported into the Element Toolbox through the Add Element Add Element button located in the toolbox from the Embedded tab.

Properties

The following properties can be changed for the pressure 4 click element:

Name

The name of the element.

Communication Mode

The communication inferface the board uses to transmit data.

SPI Driver Instance

The SPI bus used to communicate with the sensor. This should be set to whichever port the Click board is connected to.

SPI Chip Select Pin

The SPI pin used to toggle the chip select pin on the board.

I2C Driver Instance

The I2C bus used to communicate with the sensor.

I2C Address

The I2C address the element sends data to.

Triggers

The following triggers are available to execute events from within the pressure 4 click element:

Triggered

Execute an event when the source element connected to the pressure 4 click triggers.

Pressure Read

Execute an event when pressure data is read.

Temperature Read

Execute an event when temperature data is read.

Abilities

The following abilities are available for the pressure 4 click element when its source element triggers:

Trigger

Trigger the element(s) that follow the pressure 4 click element.

Read Pressure (Pa)

Read the sensor’s pressure data in pascals.

Read Temperature (°C)

Read the sensor’s temperature data in Celsius.

Element Resources

Atmosphere includes a selection of resources for users of all levels that demonstrate using the pressure 4 click element.

Demo Projects

To view the pressure 4 click element used within a project, click the demo’s name to open the project in Atmosphere and see how the element is set up.

Name Hardware Description
Arduino Pressure Click Demo Arduino Due Demonstrates using the pressure 4 click element with an Arduino Due by reading pressure and temperature data and printing it to the debug console.
BeagleBone Green Pressure 4 Click Demo BeagleBone Green Demonstrates using the pressure 4 click element with a BeagleBone Green by reading pressure and temperature data and sending the data to the cloud.
Curiosity Pressure Click Demo Curiosity PIC32MZEF 2.0 The pressure 4 click element is used in this demo by reading pressure and temperature data and sending the data to the cloud via the WiFi 7 Click board.
PIC-IoT Pressure 4 Click Demo PIC-IoT WG Demonstrates using the pressure 4 click element with a PIC-IoT WG by reading pressure and temperature data and sending the data to the cloud.
Raspberry Pi Pressure Click Demo Raspberry Pi 4 Demonstrates using the pressure 4 click element with a Raspberry Pi 4 by reading pressure and temperature data and sending the data to the cloud.