NimbleLink Skywire LTE Modem Element
The NimbleLink Skywire LTE Modem element is used to send data over a cellular network. This cellular modem communicates over UART using an AT command set. It takes several seconds to perform HTTP transactions, so it’s recommended to send data infrequently.
The NimbleLink Skywire LTE Modem is a protocol element that can be imported into the Element Toolbox through the Add Element button located in the toolbox from the Embedded tab.
The following properties can be changed for the NimbleLink Skywire LTE Modem element:
The name of the element.
UART Driver Instance
The UART driver instance to use.
NOTE: The chosen UART driver instance must be exclusive to the cellular modem. It must not be shared with debug print data.
The following triggers are available to execute events from within the NimbleLink Skywire LTE Modem element:
Execute an event when the source element connected to the NimbleLink Skywire LTE Modem triggers.
Connection Status Retrieved
Connection status retrieved. This is an integer:
The GPS location data has been retrieved. Data is of type
ATMO_3dFloatVector_t. This structure contains 3 float fields:
x- Longitude (deg)
y- Latitude (deg)
z- Altitude (m)
The following abilities are available for the NimbleLink Skywire LTE Modem element when its source element triggers:
Trigger the element(s) that follow the NimbleLink Skywire LTE Modem element.
Get Connection Status
Retrieve the connection status from the cellular driver.
Retrieve the current location data from the modem.